Disk write error updating partition table Adult dating manitoba

To find the vmhba#, use esxcfg-mpath -l Once I performed the rescan, I was able to see the actual size of 1.3TB in fdisk and create my second primary partition. I just wanted to add the info above for anyone that might run in to this problem. Would you mind creating a document for this (on the left is a link "Convert thread to document")?As you know, Windows has a built-in test tool which often warns you there is an error on your hard drive or partition.

The actual size of the lun was 1.3 TB, So I had to create a new VMFS partition on the end of the existing lun Initially I could not see more than the 667GB when I looked at the disk through fdisk. I had to run the command esxcfg-rescan vmhba X where X is the vmhba #.I have found the error most frequently when there are more than three partitions on any individual fixed drive. However if you want to place it on the same drive as the ESX base install there is no way that it can be primary and this balks at the idea of formatting. Log on to the console or use putty to connect to the ESX host remotely. If you do not use the - then you will not get root's path and thus get error messages that say that commands cannot be found.3. This will give you a list of all of your current partitions. If you are using SCSI you should see that all partitions start with /dev/sda# where # is a number from 1 to what ever. I followed this procedure yesterday, and it worked well.If you have not created a user for yourself you will not be able to log in through putty.2. Remember this list of number as you are going to be adding at least one more and will have to refer to the new partition by it's number.4. This will allow you to create a partition on the the first drive. My situation was slightly different, so I wanted to share it.partprobepartprobe Replace /dev/sd X or /dev/hd X with actual device name.Now you will able to create filesystem on new partition with the mke2fs command.

Leave a Reply